bgm says:
"These are our BGM PRO Superstrong Lambretta front brake cables. They have a strong Ø2,5mm inner cable diameter and a fixed cable holder on the outer shell. Both improve the braking process considerably. Innocenti made a similar modification in May 1966 with the last models of the DL series which were equipped with a disc brake. The cable thickness was also increased. The original cables measured by us were 6 mm outside and 1.5 mm inside
TRACTION DETAILS BGM PRO SUPERSTRONG
-
outer diameter of sheath: Ø=7mm
-
diameter inner cable: Ø= 2.5mm
-
outer diameter of pull stop/abutment: 7.5mm
PROBLEM
ex works, the original pull often has play in the abutment, which means that it is not at an exact angle to the pull stop. ="">
SOLUTION
The BGM PRO Superstrong outer shell has a fixed pressed-on abutment for the fork side.
The cable shell is thus already properly guided in the cable stop of the fork.
The working travel is shortened, the response and the feedback of the brake are significantly improved.
NOTE
The outer shell fits most Series 3 light switch housings. On very early Series 3 vehicles and Series 1 and 2 light switch housings, the outer diameter of the cable is too large to be accommodated by the light switch housing. +
BGM PRO wire rope hoists comply with the factory specification and impress with their high quality at a low price. All hoists have vehicle-specific lengths and can therefore be installed directly without reworking. Special attention was paid to high-quality details such as double-pressed end sleeves, burr-free nipples or tinned wire ends. The installation is therefore quick and easy."
